EazyClean EC 115

The EazyClean EC 115 is a textile cleaning machine for hydrocarbon solvent (KWL) with a 15 kg load capacity. It operates as a closed system with vacuum distillation and achieves a solvent recovery rate of 99.9%. The oscillating drum absorbs the forces of the spin cycle, so no anchoring to the floor is required. Compatible with all alternative solvents, including KWL, INTENSE®, SENSENE®, HIGLO®, GREEN EARTH®, and SOLVONK4®.

Technical data

• Solvent: hydrocarbon (KWL); compatible with all alternative solvents, including INTENSE®, SENSENE®, HIGLO®, GREEN EARTH® and SOLVONK4®
• Load capacity: 15 kg
• Drum volume: 300 l
• Drum: Ø 90 cm, depth 48 cm
• Loading door: Ø 50 cm
• Cleaning speed: approx. 41 rpm
• Spinning speed: 800 rpm
• Tanks: working 60 l · clean 100 l · dirty 100 l
• Filter volume: 90 l
• Minimum solvent filling: 260 l
• Distillation capacity: 80–90 l/h
• Solvent recovery: 99.9%
• Control: touchscreen, freely programmable

Dimensions and weight

• Width × depth × height: 200 × 137 × 233 cm
• Net weight: 1,670 kg
• Operational weight: 1,800 kg
• Dynamic floor load: 2,351 N

Connections

• Compressed air: 1/4″, 5 bar
• Cooling water machine: 3/4″ · distillation: 3/4″
• Water pressure: 3–5 bar, max. 20 °C
• Steam: 1/2″ · condensate: 1/2″ · steam pressure 4–6 bar
• Electrical: 3× 400 V / 50 Hz
• Max. simultaneous power consumption: 20 A (steam heated) · 32 A (electrically heated)

Technology in detail

• Round distillation: the oval base of the V4A stainless steel steam chamber directs the heat to where the solvent sits — shorter distillation times, lower energy consumption, pure solvent after every batch and straightforward sludge disposal.
• Oscillating drum: shock absorbers take up the forces of the spin cycle. This permits 400 G centrifugal force, transmits almost no vibration to the floor and makes anchoring to the foundation unnecessary.
• Concentration measurement: the actual solvent concentration in the air chamber is measured, and the control system calculates the drying time from it — rather than assuming a flat figure.
• Touchscreen: every machine function and every cleaning programme can be created, edited and copied on screen. Three password-protected authorisation levels for operator, service and management.
• OES operator software: sensors and software guide the cleaning personnel through the process.
• Closed system: 99.9% solvent recovery, with correspondingly low consumption and less finishing work.

Equipment

• Two spin disc filters (bright and dark) and one activated carbon filter
• Fresenius measurement technology for concentration determination
• Stainless steel air chamber
• Cooling unit and solvent cooler
• Needle catcher
• Dispenser pump and impregnation
• Water separator
• Vacuum distillation
• Three stainless steel tanks
• Remote maintenance (optional)

Origin

Manufactured by EazyClean Technologies in Herten, Germany.

Areas of Application

• Commercial textile cleaning with hydrocarbon solvent (KWL)
• Compatible with alternative solvents such as INTENSE®, SENSENE®, HIGLO®, GREEN EARTH® and SOLVONK4®
• Batches up to 15 kg with 300 l drum volume (drum Ø 90 cm, depth 48 cm)
• Cleaning and drying in one drum, separate solvent tanks for light and dark textiles
• Free-standing installation without floor anchoring; the oscillating drum transmits minimal vibration to the floor

Selection Notes

• Electrical supply 3× 400 V / 50 Hz; max. current 20 A steam-heated or 32 A electrically heated – specify the heating type
• For steam heating: provide a 1/2″ steam connection at 4–6 bar and a 1/2″ condensate connection
• Cooling water 3/4″ for machine and distillation, 3–5 bar, max. 20 °C; compressed air 1/4″ at 5 bar
• Dimensions 200 × 137 × 233 cm (W × D × H), operating weight 1,800 kg, dynamic floor load 2,351 N: check access route and floor
• Solvent requirement: minimum filling 260 l; distillation capacity 80–90 l/h